The all new Stage 3 Boost Cooler™ is the most advanced water-methanol injection system for your DI (direct injected/boosted) vehicle. The Stage 3 creates a 2D MAP based off of boost/fuel pressure sensor voltage to progressively command 2 Hyper-Sonic™ Nozzles independently of one another. This 2D MAP injection results in the most accurate injection curve and tune ability of any water-methanol system. Tie this in with fully terminated weather tight OEM harnessed wiring connections and the Stage 3 is the easiest and most advanced water-methanol system to install on your DI/boosted vehicle.
Kit includes:
- 300 PSI UHO (Ultra High Output) Pump
- 3 Qt Reservoir
- All Tubing Necessary for Installation
- 10' ¼ Inch High Temp Nylon Tubing
- 18" High pressure Boost Line
- Terminated Digital Variable Mapping Controller
- Terminated Plug&Play Wire Harness
- Power Solenoid Upgrade
- Level Switch Upgrade
- 2 Nozzle Holder/Check Valve Combo
- 3 Hyper-Sonic™ Nozzles
- Snow Performance Running S Decal
- Required Hardware Needed For Installation
- Comprehensive Instructions to Install on Direct Injected/EcoBoost Vehicle
- Snow Performance 1-Year Warranty