Need a way to mount your injector nozzle into your silicone or rubber intake tube? Snow Performance now offers a Nozzle Mounting Adapter for those without metal intake tubes.
Made from Delrin, the adapter is methanol resistant and highly durable. Installation is easy: simply drill a 3/4" hole using a spade bit, insert the inner adapter piece, and thread on the outer adapter nut.
1 Review
-
Product works great... instructions-not so much
I ordered the Snow bung from Edge because they are physically closer to me and faster shipping. The printed instructions stated to use a 11/16” side but, however 11/16” is way too small. I contacted Snow for clarification and they stated to have never provided instruction for an 11/16” hole. I measured and drilled a 1” hole which fit the bung, however that is too loose and I was forced to bandaid it with silicone sealant (pro tip:E6000 doesn’t stick well to silicone coupler). After some investigation, I found the proper size was listed in the product details (3/4”). Some frustrations but ultimately the product works, Snow is helpful, but the included instructions (a printed page with Snow logo) were incorrect. Shipping was fast as expected from Edge. If this bung blows out, I’m just going to get a weld-in bung.
